801S (Vibration Shock Sensor Module)
This Vibration sensor is based on the Hi high precision vibration sensor 801S, it has 2 outputs, includes TTL and analog output, the sensitivity of TTL output can be adjusted by the on-board potentiometer, you can also read the analog output with any ADC to get the vibration condition.
Specification:
- LM393, 801S
- Voltage: DC 5V
- Size: 20mm* 32mm *11mm
Features:
Sensor Module Vibration Switch
Size: 10 mm x 30 mm x height 20 mm width
Main chip: LM393, Vibration probe
Operating voltage: DC 3-5 V
Characteristics:
1, a signal having an indication at the TTL level;
2, single-channel output signal;
3, the output is a valid signal high, the light goes out;
4, sensitivity is regulated (thin tuning);
5, wide range of vibration detection, no directions;
6, with mounting holes, installation of the firmware Flexible and convenient.
Applications:
Can be used in anti-theft devices, electronic locks, MECHANICAL Vibration detection equipment, bull’s-Eye detection range has vibration testing time.
You must be logged in to post a review.
Related products
GO2Y0A21YK
GO2Y0A21YK
Infrared distance measuring sensor (including dedicated data line)Technical Parameters:
- Model : GP2Y0A21YK (GP2D12 upgrade)
- Voltage: 4.5-5. 5V
- Current: 33-40mA
- Port: Analog
- Detection distance: 10-80cm
- Data line: 3P 20cm
- Wire: 24# American standard line
- Interface: 3P DuPont SVG compatible Arduino sensor expansion board
KY-028 -Temperature sensor module (Digital)
Product Features:
- Using the NTC thermistor sensor , good sensitivity.
- The comparator output signal is clean, good waveform , driving ability , more than 15mA.
- Adjust the temperature distribution position detection threshold.
- The working voltage: DC 3.3V-5V.
- The output format : digital switching outputs ( 0 and 1 )
- A fixed bolt holes for easy installation.
- Using a wide voltage LM393 comparator.
MQ-2 (Smoke sensor-HBO, LPG, Alcohol, Propane, Hydrogen, Methane and Carbon Monoxide)
- MQ-2 Gas Sensor Module LPG, Smoke, Alcohol, Propane, Hydrogen, Methane and Carbon Monoxide Detection
- Dual signal output (analog output, and TTL level output)
- The gas, natural gas, city gas, smoke better sensitivity
- With a long service life and reliable stability
- Rapid response and recovery characteristics
MQ-6 LPG Gas Sensor Module
MQ-8 (Hydrogen Gas Sensor Module)
MQ-8 Sensor Information: sensitive material MQ- 8 gas sensors used in clean air, low conductivity tin oxide (SnO2). When there is an environment in which the combustible gas sensor, conductivity sensor with increasing concentration of combustible gases in air increases. Use simple circuit can convert the change in conductivity of the gas concentration corresponding to the output signal. MQ-8 hydrogen gas sensor of high sensitivity monitoring of other hydrogen-containing gas is also very good. The sensor can detect a variety of hydrogen-containing gas, in particular, city gas, is a low-cost sensor suitable for a variety of applications.
Sharp IR Long Range Sensor – 20 cm to 150 cm
- Infrared range finder 20cm(~8") to 150cm (~60")
- Analog interface
T000220 (Arduino TinkerKit Touch Sensor Module)
- Based on a QT 100A single touch controller
- On-board-signal amplifier
- Green LED for correct power indication
- Yellow LED whose brightness depends on the values output by the module
Reviews
There are no reviews yet.