Showing 1–12 of 19 results

1 Channel 30A relay module | 5V12V24V | with optocoupler isolation high and low level trigger for Arduino & PLC industrial control

Original price was: ₨700.00.Current price is: ₨650.00.

Introduction:

  • 5V/12V/24V 30A 1-Channel Relay Module with Optocoupler H/L Level Trigger for Arduino and industrial PLC controls
  • 30A relay module, normally used to interface the maximum load of AC 250V/30A, DV 30V/30A
  • Optical coupling isolation, driving ability is strong, stable performance
  • trigger current is 5mA
  • The module can be set at a high level or low-level trigger by using the available jumper
  • Power indicator light (green)
  • relay status indicator light (red)
  • Module Size:50mm*33mm*24mm

1-Channel Relay Module |DC 24V 30A| High Low Level Trigger with Optocoupler Isolation for PLC Automation, Equipment Control, Industrial Control

Original price was: ₨650.00.Current price is: ₨550.00.
  • Using high-power relay, the maximum control load DC 30V 30A / AC 250V 30A;
  • With each optocoupler isolation, anti-interference ability.
  • In line with international safety standards, the control area and the load area with isolation slot.
  • Each channle has a relay on LED indication.
  • Product Applications: PLC automation equipment control, industrial system control, logistics network control, home intelligent product control, electronic enthusiasts to develop experiments, all kinds of circuit modification.

4 way 5V,12V,24V/30A relay module high and low level trigger smart home & PLC industrial control

Original price was: ₨3,210.00.Current price is: ₨2,470.00.

Introduction:

4-channels independent relay module can choose to work in either Active HIGH or Active LOW condition, users can choose which channel is Active HIGH or some channels are Active LOW, can withstand current up to 30A/250VAC.

4-Channel 5V/10A Relay Module | Optocoupler isolation | low level trigger | for Arduino & PLC industrial control

Original price was: ₨480.00.Current price is: ₨430.00.

Introduction:

  1. No. of Channel: 4
  2. Trigger Voltage: 5VDC
  3. Triode drive, increasing relay coil
  4. High impedance controller pin
  5. Pull-down circuit for the avoidance of malfunction
  6. Power supply indicator and Control indicator lamp
  7. Power supply and relay instructions, lit, the disconnect is off
  8. The input signal, signal, common Terminal and start conducting

8-Channel Relay Module (12VDC)| High/Low Level Trigger with Optocoupler Isolation Load DC 30V/10A AC 250V/10A for PLC

Original price was: ₨1,850.00.Current price is: ₨1,450.00.

Introduction:

  • Module uses high-quality relay, normally open interface maximum load: AC 250V / 10A, DC 30V / 10A;
  • SMD optocoupler isolation, strong driving capability, stable performance; trigger current 5mA;
  • Each channel of the module can be set by jumper cap high or low-level trigger;
  • Power indicator (green), 8 channels relay status indicator (red)
  • Module Power Supply: 12Vļ¼ˆModule supply voltage must be DC, and the voltage to be consistent with the relay voltage).

8-Channel Relay Module (24VDC)| High/Low Level Trigger with Optocoupler Isolation Load DC 30V/10A AC 250V/10A for PLC

Original price was: ₨1,850.00.Current price is: ₨1,550.00.

Introduction:

  • Module uses high-quality relay, normally open interface maximum load: AC 250V / 10A, DC 30V / 10A;
  • SMD optocoupler isolation, strong driving capability, stable performance; trigger current 5mA;
  • Each channel of the module can be set by jumper cap high or low-level trigger;
  • Power indicator (green), 8 channels relay status indicator (red)
  • Module Power Supply: 24Vļ¼ˆModule supply voltage must be DC, and the voltage to be consistent with the relay voltage).

Arduino Multifunctional Expansion Board (Basic Learning Kit/Microcontroller Development Board)

Original price was: ₨1,150.00.Current price is: ₨1,050.00.

Product Introduction:

  • 4 digit 7-segment LED display module driven by two serial 74HC595's
  • 4 x surface mount LED's in a parallel configuration
  • 10K adjustable precision potentiometer
  • 3 x Independent push buttons
  • Piezo buzzer
  • DS18B20 temperature sensor interface
  • LM35 temperature sensor interface
  • Infrared receiver interface
  • Serial interface header for convenient connection to serial modules such as Bluetooth, wireless interface, voice module, a voice recognition module etc.

DC-DC Buck Regulator XL4015 adjustable step-down module 4~38VDC-5A

Original price was: ₨350.00.Current price is: ₨230.00.

Introduction:

The XL4015 power module is a DC to DC step-down (BUCK) power module that operates at a switching frequency of 180kHz. In such high frequency, it provides smaller sized filter components compared with low frequency switching regulators.

Module Highlights: 

  • 5A  high-power
  • high- efficiency
  • low-ripple
  • power indicator
  • heat sink

ESP-01 ESP8266 serial WIFI wireless module (Upgraded version) Wireless Transceiver ESP8266-01

Original price was: ₨1,050.00.Current price is: ₨980.00.

Introduction:

  •  High quality & low price
  •  LWIP agreement
  • Support 3 modes: AP, STA, AP+STA
  • Perfect and simple AT commands
Now Arduino can get on WiFI without breaking the bank. Use this module for your next Internet of Things (IoT) project, home automation, Or remote sensor project. This module adopts the ESP8226 IC for use over a serial connection using simple AT commands. No SPI interface or Know-How is required. 

ESP32-CAM WiFi + bluetooth Camera Module Development Board ESP32 With Camera Module OV2640

Original price was: ₨1,800.00.Current price is: ₨1,500.00.

Introduction:

The ESP32-CAM has a very competitive small-sized camera module that can operate independently as a minimum system. ESP32-CAM can be widely used in various IoT applications. It is suitable for home smart devices, industrial wireless control, wireless monitoring, QR wireless identification, wireless positioning system signals, and other IoT applications. ESP32-CAM is packaged in DIP and can be directly plugged into the backplane for quick production. It provides customers with a highly reliable connection method and is convenient for use in various IoT hardware terminals.

HC-SR501 PIR Motion Sensor Module

Original price was: ₨280.00.Current price is: ₨240.00.
The HC-SR501 Pyroelectric Infrared Sensor is used to detect the presence of people. It is commonly used in turning the lights on and off automatically when people arrive or leave. It is very reliable for robot projects which need human detection.

JDY-08 Bluetooth 4.0BLE CC2541 Master-Slave integrated support airsync iBeacon module Compatible With Arduino

Original price was: ₨1,200.00.Current price is: ₨1,050.00.

Introduction:

JDY-08 Transparent module is based on the Bluetooth 4.0 protocol standard, the working frequency band is 2.4GHZ, the modulation mode is GFSK, the maximum transmission power is 0db, the maximum transmission distance is 80 meters, adopt the TICC2541 chip design, support the user through the AT command to modify the device name, Service UUID, transmit power, matching password and other instructions, convenient and quick to use flexible.