LCD 2×16 -1602 LCD display (Development board yellow green Screen)

Description:

Features:

Pin Configuration:

The 1602 uses a standard 16-pin interface, where:

Pin 1: VSS is the ground power

Pin 2: VDD is connected to 5V positive power supply

Pin 3: V0 is the LCD contrast adjustment end. When the positive power is connected, the contrast is the weakest. When the grounding power is used, the contrast is the highest. When the contrast is too high, “ghosting” will occur. When using, you can adjust the contrast through a 10K potentiometer.

Pin 4: RS is the register selection. When the high level is selected, the data register is selected, and when the low level is selected, the instruction register is selected.

Pin 5: R/W is the read/write signal line. When it is high, it performs a read operation, and when it is low, it performs a write operation. When RS and RW are low together, the instruction or display address can be written. When RS is low, RW can read the busy signal, and when RS is high, RW can be written to the data.

Pin 6: The E terminal is the enable terminal. When the E terminal changes from a high level to a low level, the liquid crystal module executes the command.

Pins 7 to 14: D0 to D7 are 8-bit bidirectional data lines.

Pin 15: Back-light power supply positive

Pin 16: Back-light power supply negative