Hall Current Sensor Module ACS712 30A -(VCC-OUT-GND)

Description:

ACS712 30A Current Sensor is a current sensing board based on Allegro’s ACS712 magnetic linear current sensor IC. ACS712 can sense current up to bidirectional 30A with lower than 5% error. The sensor’s output is analog voltage(66mV/A).

The Allegro ACS712 provides economical and precise solutions for AC or DC current sensing in industrial, commercial, and communications systems. The device package allows for easy implementation by the customer. Typical applications include motor control, load detection and management, switched-mode power supplies, and overcurrent fault protection. The device is not intended for automotive applications. 

The device consists of a precise, low-offset, linear Hall sensor circuit with a copper conduction path located near the surface of the die. Applied current flowing through this copper conduction path generates a magnetic field which is sensed by the integrated Hall IC and converted into a proportional voltage. Device accuracy is optimized through the close proximity of the magnetic signal to the Hall transducer. A precise, proportional voltage is provided by the low-offset, chopper-stabilized BiCMOS Hall IC, which is programmed for accuracy after packaging.

The output of the device has a positive slope (>V_IOUT(Q)) when an increasing current flows through the primary copper conduction path (from pins 1 and 2, to pins 3 and 4), which is the path used for current sensing. The internal resistance of this conductive path is 1.2 mΩ typical, providing low power loss. The thickness of the copper conductor allows survival of the device at up to 5× overcurrent conditions. The terminals of the conductive path are electrically isolated from the sensor IC leads (pins 5 through 8). This allows the ACS712 current sensor IC to be used in applications requiring electrical isolation without the use of opto-isolators or other costly isolation techniques.

ACS712 30A Current Sensor uses hall effect while sensing current Because of that it can be easily used in applications that require electronic isolation. The filter pins on the board can be used to adjust the bandwidth (80kHz default) by connecting a capacitor.

General Specifications:

• Bidirectional current sensing up to 30A
• Electronic isolation by hall effect
• Adjustable bandwidth
• Wide operating temperature range

Technical Specifications:

• Operating Voltage: 3-5V
• Internal Resistance: 1.2mΩ
• Operating Temperature: -40⁰C – 85⁰C
• Weight: 1g